I have a pair of Coleman lantern chimneys that measure 4.75 ID and 5.25
tall. There is no part number but say made for coleman by Pyrex.
I removed these from an old amp and will part with them if someone has a
need for them. Email direct with an offer if interested.
73,
Larry - W7IUV
On 27-Nov-10 5:59 PM, MIKE DURKIN wrote:
>
> If there were different sizes .. might there also be different part numbers
> for them ?? IE .. I'm digging for the part number from Coleman that fits well
> for the GS35B ....
>
> Mike
> KC7NOA
>
>> From: dezrat1242@yahoo.com
>> To: amps@contesting.com
>> Date: Fri, 26 Nov 2010 23:37:20 -0800
>> Subject: Re: [Amps] GS35b teflon chimney
>>
>> ORIGINAL MESSAGE:
>>
>> On Sat, 27 Nov 2010 03:30:35 -0000, "Allan Greening"<vk3pa@vk3pa.com>
>> wrote:
>>
>>> he..or is there another type around?
>>
>> REPLY:
>>
>> A replacement glass chimney from a Coleman lantern fits perfectly and is
>> highly heat resistant. Mounting it could be a problem if you want to use
>> clamps, but I used three small dabs of RTV silicone which worked great.
>>
>> There might be more than one size so measure first. The right one leaves
>> a gap of about 1/8 inch around the tube's fins.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|