The attenuator is inside the amp, so it doesn't affect anything when the amp is
bypassed.
One nice feature when using a solid-state driver is that a 6 db attenuator
guarantees that
the swr to the exciter won't exceed 1.5:1. Of course it's only practical with
an amp that
has extra gain, like a grid-driven one.
On 11/15/2010 1:50 PM, Jim Brown wrote:
> On 11/15/2010 12:38 PM, Vic K2VCO wrote:
>> I made a 6 db attenuator for the input of my grid-driven amplifier in order
>> to bring the
>> drive requirement up a bit and to provide a better SWR for the exciter
>> during tuning.
>
> Another downside to using an attenuator between the rig and the amp is
> that unless you provide bypass switching, it's still inline when you
> want to operate without the amp.
>
> W8JI has noted the importance of using the attenuator with some more
> primitive rigs that create a full power spike when set for less than
> their max output power. This is not an issue with the K3, and I don't
> think with the MP series either, but Tom did specifically mention a
> couple of the 100W $1000 160-440 wonders as having this problem. :)
>
> 73, Jim K9YC
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|