This tube is on ebay ..
Worried about getting an older gassy tube .
The seller states ..
This auction is for One 4-250 / 5D22 Transmitting Tube. The labeling on this
tube has been worn other than the tube number that you can see in the pics. I
am not sure of the manufacturer, but I am quite sure that it is either Eimac
or
Amperex. The visible labeling on the tube reads:
JAN-CIM-5D22
Made In USA
There is a stamp inside the tube also that reads:
Q8-9034.
This tube is tested for emission from a High Voltage Transformer:
460 VAC through a 15K @ 10 watt resistor to screen
920 VAC to plate
6.3VAC @ 8 amps to filament
-40 VDC to grid
This tube tested at 200 MA.
I have no idea about testing and if that is good to determine tube emission or
not.
I have one already and thought I could have a pair for spare tubes for my
4-400A amp ? I know .. not exactly the same .. is just plate dissipation
the biggest diff? would Be able to use them as a lower power set of spare
tubes? or just make another amp with these?
I hope replies go to me as well as the list as the auction will be over in 4
hours..
Randy - N2CUA
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|