It works fine as is on the 15M position.
Carl
KM1H
----- Original Message -----
From: "tom_k1tl" <k1tl@cox.net>
To: <amps@contesting.com>
Sent: Tuesday, August 24, 2010 2:01 PM
Subject: [Amps] LK500ZC on WARC Band(s)
> Hi Folks,
> I have an Amp Supply LK500ZC which I would like to use on the WARC Bands
> (18MHz). I do not use 20m so I'm wondering if it is possible
> to use this band switch position and re-adjust the input tunning caps
> and/or
> move the 20m tap position. I don't have much equipment here
> to measure all this stuff, just an MFJ antenna analyzer.
>
> Thanks,
> Tom / k1tl...
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|