Ive pulled 700 ma out of that transformer for normal (not contesting) use
without it getting more than a bit warm.
A fat cap keeps the regulation in check.
Carl
KM1H
----- Original Message -----
From: "Vic K2VCO" <vic@rakefet.com>
To: "Amps reflector" <amps@contesting.com>
Sent: Saturday, July 24, 2010 6:04 PM
Subject: Re: [Amps] SB-200 plate voltage under load
> On 7/24/2010 12:39 PM, Carl wrote:
>> 1900-2100 depending on 120/240 fed and actual line voltage.
>
> Thanks. That agrees with the PSU Designer program. I'm using an SB-200
> transformer and
> just a bit more capacity in the supply for my 813 amplifier. I wanted to
> get a sanity
> check before cutting the pi net coils.
> --
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco/
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|