Where is that padder cap connected to if not through a hole in the chassis
to the band switch?
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Bill, W6WRT
Sent: Donnerstag, 25. März 2010 01:43
To: amps@contesting.com
Subject: Re: [Amps] placement of RF choke bypass cap.
ORIGINAL MESSAGE:
On Wed, 24 Mar 2010 16:52:45 -0400, "Carl" <km1h@jeremy.mv.com> wrote:
>
>Why doesnt RF pass thru the back of a solid parabolic reflector? Or even
>thru a mesh reflector dependent on the opening size and frequency?
REPLY:
For the third or fourth time, you are talking about RADIATED RF
energy, i.e. an electromagnetic field. The discussion regarding the
padder cap under the chassis and the load cap above the chassis was
about the flow of electrical current - two different things.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|