Bill, W6WRT wrote:
> ORIGINAL MESSAGE:
>
> On Fri, 19 Mar 2010 19:22:28 -0400, Roger <sub1@rogerhalstead.com>
> wrote:
>
>
>> I can say with certainty that an RF signal from VLF through UHF applied
>> to the inside of that wall, did not make it to the outside of that wall.
>>
>
> REPLY:
>
> If you are talking about RADIATED energy, I agree, no doubt about it.
> But our discussion is about CONDUCTED energy.
>
> So are you telling me that if you mounted a double female bulkhead
> coax connector to the screen and fed RF energy into it, there would be
> nothing getting to the other side? Or that only energy from the center
> conductor would go through and the shield side would not?
>
> I find that hard to believe.
>
Yup as long as the connector doesn't go "through" the screen, providing
a path not connected to the screen.
As I said, it's counter intuitive.
73
Roger (K8RI)
> 73, Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|