Question. Are the plugin thermal delay relays still manufactured. We used
them a lot twenty five years ago in manufacturing and large scale
refrigeration control. They plugged into an octal socket and had beefy
contacts. They were relativly inexpensive at the time.
Jim
----- Original Message -----
From: "Gary Schafer" <garyschafer@comcast.net>
To: <Amps@contesting.com>
Sent: Thursday, March 04, 2010 12:53 PM
Subject: [Amps] Solid state relays and step start
> Has anyone had problems using a solid state relay to short out the step
> start resistor in a power supply?
>
> I have heard of problems of not enough current thru the SS relays (when
> amp
> is in standby) when used as the primary on/off relay. Sometimes a resistor
> has to be placed in parallel with the transformer primary so the relay
> works
> properly.
>
> When used in a step start circuit the current could be quite low as well
> as
> the voltage at the relay due to the resistor across the relay. Any issues
> here?
>
> 73
> Gary K4FMX
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.733 / Virus Database: 271.1.1/2721 - Release Date: 03/03/10
11:34:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|