Amps
[Top] [All Lists]

Re: [Amps] soft start, how to determine if needed?

To: dezrat1242@yahoo.com
Subject: Re: [Amps] soft start, how to determine if needed?
From: Roger <sub1@rogerhalstead.com>
Date: Mon, 01 Mar 2010 20:28:46 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>

Bill, W6WRT wrote:
> ORIGINAL MESSAGE:
>
> On Sun, 28 Feb 2010 09:58:56 +0200, "Alex Eban" <alexeban@gmail.com>
> wrote:
>
>   
>> By the way, an old trick that was used in tube type TV sets was to install a
>> thermistor in series with the mains.
>>     
>
> REPLY:
>
> That thermistor was not used for soft start. It was part of the
> degaussing system and had very poor reliability. I changed hundreds of
> them over the years. Not recommended.
>   
I'll bet you replaced almost as many, if not more than tubes.  Typically 
the set would just quit rather than some indication of imminent failure 
that tubes often gave. 

Yes, I also repaired tube type TV sets in a prior life. Even build a TV 
set (B&W) in with a correspondence course.

73

Roger (K8RI)
> 73, Bill W6WRT
>
>   
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>