I would think between center tap and the end winding as that is all that is
active at any given time.
73
Gary K4FMX
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]
> On Behalf Of Barrie Smith
> Sent: Tuesday, February 23, 2010 1:29 PM
> To: Amps@contesting.com
> Subject: [Amps] Secondary resistance
>
> When using Duncan Amps power supply designer, how do you properly
> measure the secondary resistance on a center-tapped transformer?
>
> Do you measure the whole winding, or from center-tap to the outside of
> one winding?
>
> 73, Barrie, W7ALW
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|