Amps
[Top] [All Lists]

Re: [Amps] GS-35B Input

To: "'MIKE DURKIN'" <patriot121@msn.com>, "'amps fourm'" <amps@contesting.com>
Subject: Re: [Amps] GS-35B Input
From: "Gary Schafer" <garyschafer@comcast.net>
Reply-to: garyschafer@comcast.net
Date: Sun, 21 Feb 2010 16:42:36 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Mike,

Leave the CLC (pi network) input circuit in there. A broadband input will
not provide the flywheel effect that you need. Neither will an LCL do the
job as there needs to be capacitance from cathode to ground that you only
get with the CLC type or a parallel tuned input circuit.

73
Gary  K4FMX

> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]
> On Behalf Of MIKE DURKIN
> Sent: Thursday, February 18, 2010 1:34 AM
> To: amps fourm
> Subject: Re: [Amps] GS-35B Input
> 
> 
> Ok that didnt work so great .. but using a power combiner/splitter with
> 1100pF in the same setup did show a workable bandwidth and didnt go
> above a 1.5SWR .... looks like i might just use this configuration and
> eventually pull the C L C networks for the input of my amp ....
> 
> Mike
> KC7NOA
> 
> > From: patriot121@msn.com
> > To: amps@contesting.com
> > Date: Wed, 17 Feb 2010 21:48:53 -0800
> > Subject: Re: [Amps] GS-35B Input
> >
> >
> > I was thinking of using one of those bi-ocular transformers that's
> found in many solid state transceivers .... but changed to 1:1 and
> basically an C L to ground and the other half of the 1:1 would be L C
> Into the GS-35B .... guess ill just try it with a dummy load and my
> MFJ259b ..... at least ill know the frequency range of the 1:1
> >
> > Mike
> > KC7NOA
> >
> > > Date: Wed, 17 Feb 2010 20:19:16 -0600
> > > From:
> > > CC: amps@contesting.com
> > > Subject: Re: [Amps] GS-35B Input
> > >
> > > I think large variations in drive impedence through the rf cycle are
> > > somewhat smoothed out by a low to medium Q input..   BTW, L-C-L (
> > > lowpass ) might be better.
> > >
> > > Don WA4NPL
> > >
> > >
> > >
> > >
> > >
> > >
> > > Quoting "MIKE DURKIN" <patriot121@msn.com>:
> > >
> > > >
> > > > Just a thought/wondering .. why is it that a broad-band 1:1
> torroid
> > > > un-unun not used for the input of a single GS-35b instead of
> several
> > > > C.L.C. networks ?? Is there not enough fly-wheel effect to keep a
> > > > good linearity??
> > > >
> > > >
> > > >
> > > > Mike
> > > >
> > > > KC7NOA
> > > >
> > > > _________________________________________________________________
> > > > Hotmail: Trusted email with powerful SPAM protection.
> > > > http://clk.atdmt.com/GBL/go/201469227/direct/01/
> > > > _______________________________________________
> > > > Amps mailing list
> > > > Amps@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/amps
> > > >
> > >
> > >
> > > _______________________________________________
> > > Amps mailing list
> > > Amps@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/amps
> >
> > _________________________________________________________________
> > Hotmail: Free, trusted and rich email service.
> > http://clk.atdmt.com/GBL/go/201469228/direct/01/
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> 
> _________________________________________________________________
> Hotmail: Powerful Free email with security by Microsoft.
> http://clk.atdmt.com/GBL/go/201469230/direct/01/
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>