| To: | amps@contesting.com |
|---|---|
| Subject: | Re: [Amps] Need help with ARD 230A |
| From: | k3rww@comcast.net |
| Date: | Sun, 17 Jan 2010 22:57:15 +0000 (UTC) |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
Hello I just was wondering if someone out there could help me with ARD 230A problem .After the initial warm up period the "not ready" light remains on.If I put the amp in manual mode,it still is on.At no point in manual mode will the Tune/Load motors move.I suspect that the EPROM has dumped/lost its memory.Any help would be appreciated.Thanks Leslie;K3RWW _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Amps] kenwood tl 922 band switch, caroll wallace |
|---|---|
| Next by Date: | Re: [Amps] Need help with ARD 230A, k3rww |
| Previous by Thread: | [Amps] kenwood tl 922 band switch, caroll wallace |
| Next by Thread: | Re: [Amps] Need help with ARD 230A, k3rww |
| Indexes: | [Date] [Thread] [Top] [All Lists] |