Karl-Arne wrote in part:
> A PI-L network using a plate load impedance of 2800 ohms
> and an
> intermediate impedance of 200 ohms would be a good
> starting point.
Current in the PI and the L inductors will be
similar unless network Q is high.
Get PI-L designer here:
http://tonnesoftware.com/piel.html
Not only does design but also analysis including
both frequency-response plot (including return
loss) but also peak voltage across capacitors
and RMS current through inductors.
Its also on the ARRL HB CD if that is of interest.
- Jim W4ENE
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|