Amps
[Top] [All Lists]

Re: [Amps] Checking Plate Choke resonance

To: <amps@contesting.com>
Subject: Re: [Amps] Checking Plate Choke resonance
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
Reply-to: dezrat1242@yahoo.com
Date: Tue, 13 Oct 2009 19:43:32 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
ORIGINAL MESSAGE:

On Tue, 13 Oct 2009 20:07:55 -0500, "Jeff Blaine AC0C"
<keepwalking188@yahoo.com> wrote:

>
>I am a bit confused on this.
>
>It's been a while - but I was thinking that I read one time on RM's site 
>about creating an intentional parallel resonance on the filament choke. 
>That's a different part, but it seems the principle would be the same.

REPLY:

Parallel resonance is not a problem if the components can handle it. In the
filament (input) circuit, the power is much less and the choke wires are much
larger (typ 12-14 gage) than in the plate circuit.

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>