You have to measure the voltage first and not believe everything you read.
Carl
KM1H
----- Original Message -----
From: "Szegedy" <szegedy.zolilaci@t-online.hu>
To: <amps@contesting.com>
Sent: Tuesday, September 15, 2009 7:26 PM
Subject: [Amps] TL-922 without modification
> Dear Friends!
>
> 1.I have a TL-922 in original state,no any modification .Linear works ,but
> is it a probleme if I use it without modification?
> 2.Which is the the most important to modify? I red on a forum :filament
> voltage is too high?How is it?Kenwood made a mistake?
> The line voltage is 220V in my QTH,my linear is set to 220V now,but it is
> not good for a tubes?
> What about if I dont modify the linear inside but I set the lnput voltage
> terminal board of TL-922 to 240V ( with shorting bar at the rear of
> linear )?Will it be better for tube(longer life of tube)?
> Lower filament voltage will be?But lower power out? How much? Not 1KW
> ,only 900W will be?But much more tube life? Kenwood made a mistake?
>
> Thanks:Laszlo HA5BZR
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|