ORIGINAL MESSAGE:
On Wed, 26 Aug 2009 20:04:34 -0400, "Carl" <km1h@jeremy.mv.com> wrote:
>
>There is no socket issue as it does not use one. The base connections are
>cocentric rings and the tube is designed for UHF cavities.
REPLY:
At least one ham did homebrew a socket for this tube:
http://www.nd2x.net/gs23b-socket.html
It's clever how he used an SO-239 connector for the heater pin.
But that looks like a lot of work. I think just clamping the grid flange to the
chassis and using homebrew clamp rings for the other elements would be good
enough and much easier. We'll see.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|