Would someone please fill me in with the distinction between synchronous and
asynchronous?
David
G3UNA
----- Original Message -----
From: "Ian White GM3SEK" <gm3sek@ifwtech.co.uk>
To: <amps@contesting.com>
Sent: Saturday, August 01, 2009 8:30 PM
Subject: Re: [Amps] Asynchronous coax matching transformer
K5GW wrote:
>Hi all,in addition to the examples Larry offered, the scheme will also
>match impedances less than 50 ohms, down to 22.2 ohms if I remember
>correctly.
>
Thanks to Larry and Gerald for pointing out that the series method is
much more versatile than I had imagined.
>A two way power divider where two 50 ohm loads are in parallel
>requires a 25 to 50 ohm transformer which is easily handled with the
>series matching method.
>
>The only down side is the difficulty in adjusting the matching sections.
>On the other hand, transmission line calculations via Smith Chart or
>computer program will give the exact lengths in degrees needed so
>tuning is not a real requirement anyway.
>
Greg Ordy's program takes care of that, and also says when a match is
not possible.
>If the sections are joined via coax connectors, you have to take into
>account where 75 ohms ends and 50 ohms begins. The connectors are
>invariably of a 50 ohm type and their internal length must be added to
>the 50 ohm part of the matching section.
>
>The last issue is velocity factor of the coax and connectors. A serious
>builder will be prepared to confirm these quantities before cutting the
>matching sections to length.
>
Connectors wouldn't seem to be a major issue up to 50MHz. Wherever
paralleled cables are required, I find it easier to not to use
connectors at all, but to splice the cables by soldering.
>It is a real joy to go through the numbers and have the transformer turn
>out right on frequency.
>
Oh yes!
--
73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|