ORIGINAL MESSAGE:
On Fri, 08 May 2009 10:51:46 +0200, Walter Muth
<wmuth@rbwelektronik.de> wrote:
>Missing a nut on the ground lug of the SG-230 tuner, so what type of
>thread is it and what would be the correct technical term/size of the
>screw nut?
REPLY:
In case you don't get an answer from an actual owner, I can take a
guess. Screws and nuts for that purpose are almost invariably either
6-32, 8-32 or 10-32 thread. If it is larger, about the diameter of a
pencil, that would be 1/4-20 thread but that would be unusual.
If you can measure the diameter of the hole in mm and send it to me, I
will figure out which it is.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|