Perhaps I was oversimplfying - I spend much of my day distilling complex
technical issues to bullets the non-technical can understand. I meant
single frequency as opposed to frequency agile transmittters like modern
HF rigs with a 25:1 frequency range
- Scott
Jim Brown wrote:
> On Thu, 23 Apr 2009 14:02:28 -0400, Scott McGrath wrote:
>
>
>> In the case of a broadcast system you are setting up a single frequency
>> system and you want all the components to have an impedance match as you
>> want as much of the power as humanly possible to be radiated by the
>> purpose built antenna, You do not want the RF bouncing around the
>> transmission system creating heat.
>>
>
> Few broadcast systems are "single frequency." They may have a single
> carrier, but most are concerned with good phase response over some finite
> bandwidth depending on what modulation scheme is employed. With FM,
> that's at least 200 kHz. With TV, it's 6 MHz. With AM, it's at least 20
> kHz. With all of these systems, non-ideal amplitude and phase response
> creates distortion.
>
> I grew up a few miles from an AM station with a 4-tower array on 930 kHz,
> and during my college years, worked for them. Directional AM antennas are
> designed to generate a null in their pattern in the direction of another
> station on the same frequency, and nulls are the result of precise
> cancellation between two or more wavefronts. When I drove through one of
> the nulls in their pattern, the carrier went away but the sidebands were
> loud and clear. A bit further up or down the road, the sidebands went
> swishy. Just one example of non-flat amplitude and phase response
> creating distortion. Multi-path is another example. One of the reasons
> that few TV stations on the low-band VHF channels (2-6) use multi-bay
> antennas is that it's difficult to get good phase response over that
> relatively high percentage bandwidth (more than 10% on Ch 2).
>
> To have good phase response, the load Z needs to be flat over the full
> modulated bandwidth. That's another BIG reason why low SWR is critical in
> broadcast. Yes, heat and voltage are important too.
>
> 73,
>
> Jim Brown K9YC
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|