It will work with any amplifier. It's controlling the idle current. Fern
----- Original Message -----
From: "Peter Voelpel" <df3kv@t-online.de>
To: <amps@contesting.com>
Sent: Saturday, March 14, 2009 12:56 PM
Subject: Re: [Amps] 8122 op temp in NCL-2000 amp
Hi Fern,
Sure those are for use with grid driven AB1 tetrodes?
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Fern
Sent: Samstag, 14. März 2009 19:21
To: Frank T Brady; amps@contesting.com
Subject: Re: [Amps] 8122 op temp in NCL-2000 amp
Hi Frank: Your amp certainly looks like a perfect candidate to install an
electronic vox biasing board to drop that needless high idling current to
almost zero Ameritron has those boards available at a very reasonable price.
Fern
>I operate SSB with my NCL-2000 only to chase 'new ones'.
> While doing this on 17m I noticed that the top lid above the tubes was
>awfully hot.
> The high temperature persisted in SSB mode even if I wasn't transmitting.
> SSB uses approx 2800v and idle current is 200 ma.
> I put a digital thermometer on the lid above the tubes and recorded
>some
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.278 / Virus Database: 270.11.13/2001 - Release Date: 03/14/09
06:54:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|