I'm using GM3SEK's Triode Board for my 6m amp project using the GI-7B, i ran
into a problem today with the power supply. According to his manual, i sent
him an email as well waiting for a reply, for 2500v i should use 10 1M Ohm
resistors in series from the B+ line, on the end of that string of resistors
there is also two 100k 1W resistors to chassis ground. My supply is 2400V,
measured with a HV meter i get 2380V.
The problem is the output of that divider is supposed to be 12v or less. I put
the positive of my meter on the end of the chain of resistors and i put the
negative to chassis, 0V, nothing nada. Then i put the negative to the 0V lug
on the secondary of the transformer and i get 113V.
How is this supposed to work that i can get 12v from it?????
73,
Scott KBØNLY
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|