Fern,
If you run much RTTY, you can appreciate the hammering running full out
on that band can do to a rig barefoot...
I would be very interested to see what the answer comes up to be as
well. Most amps I've seen will load up on 30m in the 20m position,
albeit with some compromise in tuning range and usually lousy SWR if the
input network has a Q above about 2.5.
73/jeff/ac0c
Fern wrote:
> Yes Paul but still the gentleman's agreement was to NOT use amps or high
> power on that band! Fern
>
>
> ----- Original Message -----
> From: "Paul M Dunphy" <paul_dunphy@ve1dx.net>
> To: "Fern" <crc@cyberlink.bc.ca>; <amps@contesting.com>
> Sent: Saturday, February 28, 2009 10:25 AM
> Subject: Re: [Amps] QRO HF-2500DX on 10.1 MHz (Proper title!)
>
>
>
>> At 01:17 PM 2/28/2009, Fern wrote:
>>
>>> Hi Paul:
>>>
>>> I didn't think that linear amps were allowed on that band. Fern
>>> VE7GZ
>>>
>>>
>> That restriction (in Canada) was removed at least 10 years ago. US
>> stations are still restricted to 200 watts, but our 100 watt limit was
>> removed ~2000. My ACOM-1000 works on 30M, as do most Ameritron amps, etc.
>>
>> I asked the question because the QRO HF-2500DX is USA made and would
>> not be allowed to operate on 30M for their domestic use, but certainly we
>> could use it here.
>>
>> 73, Paul VE1DX
>>
>>
>>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|