Bob:
I purchased the LDG AT-100 AMP package and installed it in an amp using a
pair of 3-400Z's I will have to say it was expensive, since they had
discontinued the original package, but it did a great job. You had to buy
the AT-100 and tear it apart for the circuit board. Great support, so it
worked out fine.
I have an input SWR of !.2:1 maximum and the Yaesu FT-2000, the ICOM 746
and the Heath SB-101 in my shack all have no problems driving the amp.
Chuck W9POU
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of kc0hfl@cox.net
Sent: Wednesday, February 11, 2009 9:25 PM
To: Amps@contesting.com
Subject: [Amps] Autotuners in Amps
I seen the new handbook had an amp project using an LDG auto tuner for the
tuned input and was curious what the groups thoughts was on this. After some
research I came across an add where LDG actually marketed a tuner for this
but has been discontinued. Seems like a good idea or is it?
73, Bob kc0hfl
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|