Hi Jim,
I agree 101% --- that's all I ever do here with my HV B+ leads (maximum
2800-VDC)...
I even dispense with the Millen HV connectors, & instead, use GOOD QUALITY
PL-259 connectors / SO-239 receptacles to inter-connect the RF deck with the
remote high-voltage power supply.
Never EVER experienced so much as even one single failure, in some 30-plus
years of near daily use.
~73~ Eddy VE3CUI - VE3XZ
**************************************
----- Original Message -----
From: "Jan Erik Holm" <sm2ekm@telia.com>
Cc: <amps@contesting.com>
Sent: Tuesday, December 23, 2008 8:51 AM
Subject: Re: [Amps] High voltage wire
> Yes but why make it more difficult then need be.
>
> Just run RG213 ground the shield and be done with it.
>
> / Jim SM2EKM
> -----------------------
> Barry Kirkwood wrote:
> > FWIW:
> >
> > Things I have done that worked and did not kill anyone, but may not be
best
> > practice:
> >
> >
> > 2. HT lead between homebrew 4-1000 amp and external power supply. Again
> > used ignition wire, protected with clear polythene tube available fro
most
> > hardware suppliers. Poly tube secured with clamps to chassis at each
end.
> > idea was to protect cable and provide extra insulation.
> >
> > 73 es seasons greetings
> > Barry ZL1DD
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|