I have an Ameritron AL-811 Amplifier and before I blow it up I have a
question.
The instruction manual is not very clear on this issue.
As to the load control, the book says to set it at 4 1/2 at 4.0 MHz.
I find that at 3.983, after I adjust the plate for maximum output I end up
with the plate control at 5 which is very close to the recommended starting
point of 5 1/2.
However, I get more output if I turn the Load control down to about 1 with
the same input power from the exciter.
The question is should I leave the load control at 4 and 1/2 or run it down
to 1?
I like to run the amplifier at a maximum of 400 watts CW so as not to push
things.
I can get to that power level easy either way on the load control setting
and still be within the 200 ma grid current maximum recommend by Ameritron.
The only difference I notice is that a load control setting of 1 gets me to
400 watts with less exciter power.
Bottom line is I need a lesson on how to properly tune the amp and proper
settings of the plate and load controls.
This may be a dumb question to some but I fell better safe and proper use.
Thanks,
Dan/N4VET
**************Psssst...Have you heard the news? There's a new fashion blog,
plus the latest fall trends and hair styles at StyleList.com.
(http://www.stylelist.com/trends?ncid=aolsty00050000000014)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|