What is wrong with the fan? Is the motor defective? It's just a small shaded
pole motor that may be available from WW Granger or other source.
73
Jim W7RY
----- Original Message -----
From: John E. Cleeve
To: 'Dave Bowker'
Cc: amps@contesting.com
Sent: Saturday, September 06, 2008 5:14 AM
Subject: Re: [Amps] Titan fan
Hello Dave,
Yes, I think that you are correct; the figures would need amending for two
tubes, and, I assume how the airflow is fed to the tube bases, that is, a
single air chamber beneath two tube bases, or two separate bases with a "Y"
hose connection to a single fan. A simple "U" tube water manometer, was
shown in several "tube period" ARRL handbooks, to aid the checking of "back
pressure", but I do not have access to a Titan, to carry out any
measurements. It just seemed unfair to me, that there appeared to be no
information on replacing an obsolete defunct Titan fan. Perhaps if you have
a greater knowledge of the subject/fans, you could amend my offering to the
reflector? Sincerely, John.
_____
From: Dave Bowker [mailto:dbowker@sjv.net]
Sent: 06 September 2008 12:44
To: g3jvc@jcleeve.idps.co.uk
Subject: [Amps] Titan fan
John,
The figure specified on Eimac data sheets is for ONE tube. I believe your
calculation is for one tube --- am I correct?
73, Dave, K1FK
Fort Kent, ME
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.169 / Virus Database: 270.6.17/1655 - Release Date: 05/09/2008
19:05
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|