A 1.2:1 VSWR isnt sufficient?
Carl
KM1H
----- Original Message -----
From: "Alton McConnell Avon-Cadillac" <amcconnell@avonauto.com>
To: <amps@contesting.com>
Sent: Monday, June 09, 2008 8:03 AM
Subject: [Amps] W3NQN band pass filters
>I am trying to align some W3NQN band pass filters that I have built for
> club use. I am using the design from the May and June 1998 QST article.
>
> I am using a HP 8656 Signal generator and a 30 MHz scope for the tuning.
> Measuring the return loss with a MFJ 269 SWR analyzer, the best that I
> can do is 20db.
>
> Any suggestions for alignment of the filters?
>
> Alton, NU8L
> Amcconnell3@hotmail.com
>
>
> This e-mail and any files transmitted with it are the property of Avon
> Automotive, are confidential, and are intended solely for the use of the
> individual or entity to whom this e-mail is addressed. If you are not one
> of the named recipients or otherwise have reason to believe that you have
> received this e-mail in error, please notify the sender and delete this
> message immediately. Any other use, retention, dissemination, forwarding,
> printing or copying of this e-mail is strictly prohibited.
>
> The views, opinions, conclusions and other informations expressed in this
> electronic mail are neither given nor endorsed by Avon Automotive unless
> otherwise indicated by an authorized representative independent of this
> message.
>
>
> This message has been scanned for malware by SurfControl plc.
> www.surfcontrol.com
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|