Jeff,
At the end of the day, it was quite simple... An adaptor from 8 1/8 to Bird
QC, then to 7/16
The bits that I found to be hard to find was the adaptor and the internal
bullet. The QC adaptor to 7/16 is perhaps the easiest part...
I got the bits from www.economyelectronics.com
Hope that helps..
Andy
http://gd0tep.com
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Jeff Carter
Sent: 16 April 2008 20:28
To: amps@contesting.com
Subject: Re: [Amps] 3 1/8 to 7/16 ?
Hi Andy,
What was the best solution, in case this comes up again? It seems
like a good bit of data to file back for future use.
Thanks,
Jeff/KD4RBG
---- Original message ----
>Date: Wed, 16 Apr 2008 17:34:33 +0100
>From: "Andy GD0TEP" <andy@gd0tep.com>
>Subject: Re: [Amps] 3 1/8 to 7/16 ?
>To: "'Amp Reflector'" <amps@contesting.com>
>
>Thanks to everyone that responded to my enquiry, I now have a suitable
>adaptor on the way from America.
>
>73
>Andy
>http://gd0tep.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|