Bob:
I have SPICE models for various tube amps that I have created over the years.
I have a 4-1000 model. You are welcome to it if you want it, but you'll need
LT Spice from Linear Tech, which is free (www.linear.com). It is by far the
best free SPICE. I don't even renew the SPICE software license at work anymore
because it is that good.
BTW: Anyone else is welcome to these SPICE models and the Matlab code I use to
generate the tube transfer funtion.
I ran a simulation and I see vrtually no plate current drawn for a grounded
grid 4-1K with Ep = 1500V. You did not give the bias, but with 0V between grid
and cathode, and the screen grid at ground, there is no current (~ 1 ua). I
then referred to my 4-1K datasheet. Eimac only has one constant current
characteristic plot for screen voltage of +500V, therefore, I can't directly
compare your result. However, when I change the screen voltage to 500V from 0V
(floating it from the control grid), the quiescent Ip is 820 ma, which agrees
with the constant current plot in the datasheet (it has to, my 4-1K model was
derived from that datasheet constant current plot). If you want a copy of the
datasheet, I can email it to you. A British ham has these on a website
(g8wrb.com).
I have checked my models carefully against the load lines for many tubes. I
have validated other operating cases, and use it for amplifier design.
Therefore, I don't think the 4-1K is bad, you just need to compare opereating
points to the datasheet. Try other biases and plate voltages, and see if you
emulate load lines in the constant current plot in the datasheet.
Suffice it to say, a 4-1000 in grounded grid (screen and control grid at DC
ground) has very low gain.
Email if you want the SPICE and Matlab files. The SPICE file already has the
4-1K model in it.
73,
Steve, K0SF
----- Original Message -----
From: "Robert Groh" <rgroh@swbell.net>
To: amps@contesting.com
Sent: Sunday, July 15, 2007 12:43:17 AM (GMT-0600) America/Chicago
Subject: [Amps] Question about 4-1000A operation
Well, I've got a bit of a problem and would like some opinions. Another ham
tried out one of my 4-1000A tubes and reports the following:
Filament fine, tube lights up fine
He ran it with filament only for 4 hours and then applied 1500V to the plate
Result: no grid current
Another 4-1000A tube was tried in same circuit and gave 50 mA idling current.
I'm not sure what exact circuit he is using - probably grounded grid. No idea
of what screen voltage.
So it seems that my tube is no good. Any other possibilities we should try
before converting it into a table lamp?
73
Bob, WA2CKY
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|