| To: | <amps@contesting.com> |
|---|---|
| Subject: | [Amps] LA 100A |
| From: | "Sarge" <sarge@36db.com> |
| Reply-to: | Sarge <sarge@36db.com> |
| Date: | Fri, 25 May 2007 20:49:22 -0500 |
| List-post: | <mailto:amps@contesting.com> |
I have an Amp Supply LA 100A. It says it has tuned input via built in pc board. So do I need the ARB 704 or whatever it is for an interface between my TS 570S or just a relay cable? Thanks, Sarge W5SRG _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] attaching a heat spreader to a heat sink, Robert Bonner |
|---|---|
| Next by Date: | Re: [Amps] FW: attaching a heat spreader to a heat sink, jeremy-ca |
| Previous by Thread: | [Amps] About ampl FL2100, Eduardo Somoano |
| Next by Thread: | [Amps] 3 phase to single phase conversion, kf8od |
| Indexes: | [Date] [Thread] [Top] [All Lists] |