Hi all try a small amount of Coax Seal on the end of a phillips it works
great!
73 Sam KF4YOX
----- Original Message -----
From: "Ian White GM3SEK" <gm3sek@ifwtech.co.uk>
To: <amps@contesting.com>
Sent: Friday, March 23, 2007 3:38 AM
Subject: Re: [Amps] Bee's wax to hold screws
> bob finger wrote:
>
>>Gary Schafer wrote:
>>
>>>I have to share this with others as it worked so well. While working on
>>>an
>>>amplifier I had some small screws to remove and replace that were buried
>>>deep where you could only get a screw driver in and not even room for a
>>>pair
>>>of long nose pliers.
>>>
>>>I loosened the screws up to where they were almost out. Then put a very
>>>small piece of bee's wax on the end of the screw driver. It held the
>>>screw
>>>very well for removal and subsequent reinstallation.
>>>
>>>These were Phillips head screws. I don't know of a tool made to hold
>>>them.
>>>
>>>
>>>
>>>Where do you get bee's wax? I found some in an old IF can from an old
>>>radio.
>>>The coil was covered with it. Just a very small amount is needed. I
>>>removed
>>>and reused the same small piece of wax for several different screws.
>>>
>>>
>>>
>>>Hope this saves you some grief some day.
>>>
>>>
>>If you can't locate beeswax use a very small piece of warm (in your
>>hand) duct seal. Available in any hardware store. I think it works
>>better than beeswax, but then why take the time to compare, use what you
>>have. 73 bob de w9ge
>
>
> Blu-Tack, superglue - whatever it takes.
>
>
> --
>
> 73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
> http://www.ifwtech.co.uk/g3sek
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|