Roger D Johnson wrote:
>I was using this program to play around with power supply designs
>and I noticed something strange. If I expand the trace and look at
>the ripple component, the maximum voltage reported in the panel
>on the right looks OK but the minimum voltage seems all wrong.
>Am I interpreting these voltages correctly or is there a bug in the
>program?
>
The minimum voltage will the lowest value at any time. If the time span
includes switch-on from zero, then for sure the reported minimum value
will look low.
The answer is to use the program's "reporting delay" feature to make it
ignore the switch-on transients.
--
73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|