Robert B. Bonner wrote:
>>From what I understand the 3CPX1500 5.5v filament is a PULSE SPEC. It is
> the same filament as in an 8877. The guy emailing REID, as that one too...
There's a specific note in the 'CPX data sheet about heater voltage -
basically recommending operation at 5V unless peak current above 24A
(very short pulses) is needed. With 5.5V up to 50A peak is available for
the shortest pulses. At both voltages, the maximum current at 1sec or
longer is 1A. Longer tube life is given as a benefit of lower voltage.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|