| To: | Amps@contesting.com |
|---|---|
| Subject: | Re: [Amps] drill bits |
| From: | W2RU - Bud Hippisley <W2RU@frontiernet.net> |
| Date: | Wed, 01 Nov 2006 00:04:55 +0000 |
| List-post: | <mailto:amps@contesting.com> |
This is not a "drilling steel" question, it's a "drilling aluminum" one. I have a Sears drill press, and can vary the speed, as needed. Can someone tell me how to drill small holes (for pots, 1/8-inch phone jacks, RCA phono jacks, etc.) in typical small aluminum chassis (plural) so that the holes aren't triangular? Bud, W2RU _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] drill bits, wc6w@juno.com |
|---|---|
| Next by Date: | [Amps] Transistor supplier, Steve Thompson |
| Previous by Thread: | [Amps] drill bits, Doug Charette |
| Next by Thread: | Re: [Amps] drill bits, Doug Renwick |
| Indexes: | [Date] [Thread] [Top] [All Lists] |