Sure, no problem, but would it be hard enough to disable?
73, Pete
At 04:25 PM 10/14/2006, Robert Chudek - KØRC wrote:
>It appears most everyone is thinking about controlling/disabling the RF. Take
>the focus off 21 ~ 30 MHz RF solutions for a moment.
>
>What's to say the internal frequency detector couldn't manage the HV or Bias
>supplies to disable amplification when detecting 26 ~ 28 MHz?
>
>73 de Bob - KØRC in MN
>
>
>------------------------------
>
>Message: 7
>Date: Sat, 14 Oct 2006 09:13:43 -0400
>From: Pete Smith <n4zr@contesting.com>
>Subject: Re: [Amps] Amplifier Rule Changes in the new R&O
>To: "Paul Christensen" <w9ac@arrl.net>, <amps@contesting.com>
>Message-ID: <6.2.0.14.2.20061014091047.03d2ae00@mail.adelphia.net>
>Content-Type: text/plain; charset="us-ascii"
>
>I couldn't agree more, Paul - but my point was precisely that it DOESN'T
>change anything for manual amps - the only way to meet the requirement is to
>continue to stop at 15 meters. I'm a little concerned, though, that the "NOT
>easily modifiable" requirement might even preclude sale of existing manual
>amps, unless their certification is grandfathered. After all, don't some of
>them require just cutting a single wire or changing the plate choke?
>
>73, Pete N4ZR
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|