On Jun 23, 2006, at 3:49 PM, m.ford wrote:
>
> ----- Original Message ----- From: "R L Measures" <r@somis.org>
> To: "Glenn McNeil" <vk4tzl@bigpond.net.au>
> Cc: <amps@contesting.com>
> Sent: Thursday, June 08, 2006 9:09 AM
> Subject: Re: [Amps] RCA 8122 Tubes
>
>
>> On Jun 8, 2006, at 1:55 AM, Glenn McNeil wrote:
>>> Hello Gang,
>>>
>>> I've just been given a pair of RCA 8122 Tubes...never used,
>>> still in the
>>> original boxes. Date code 69-04.
>>>
>>> What are the chances they are still OK for use ?
>> Very good if the Al-Ox ceramic has a purplish color from added
>> manganese. A high-potential tester will give the answer is
>> seconds. With 5kV between the anode and screen, there should be
>> less than 5uA of leakage. i would not uses these tubes in a
>> unmodified NCL-2000.
>
> The best modification for the NCL-2000 is to change the way the
> operator abuses it.
> Keep the meter in screen current and watch it all the time. I'll
> bet it was all the gg guys that got
> caught looking at the grid current that gave the amp a bad name.
Not using the Eimac-recommended current-limiting screen shunt
regulator circuit for small tetrodes gave the NCL-2000 its reputation.
>
> Mike k1ern
>
>
>
>>>
>>> Any ideas
>>>
>>> 73
>>>
>>> Glenn
>>> VK4TZL
>>>
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>>
>> R L MEASURES, AG6K. 805-386-3734
>> r@somis.org
>> _______________________________________________
>
>
R L MEASURES, AG6K. 805-386-3734
r@somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|