Tony said...
"There is no use wasting another tube and increasing the demand for
filament current, plate current AND lowering your plate load impedance
by using two tubes."
Tony, huh?,
You would not increase your plate current or lower your plate load
impedance if you ran the same legal power limit with either one or a
pair of those tubes. (Besides, lowering plate Z is not necessarily a bad
thing? Your tank circuit runs more efficiently with a lower ratio of
in/out transformation).
73, Roy K6XK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|