Amps
[Top] [All Lists]

Re: [Amps] Vegetable oil dummy load

To: "Larry Carman" <lncarman@swbell.net>,"HAROLD B MANDEL" <ka1xo@juno.com>
Subject: Re: [Amps] Vegetable oil dummy load
From: "Partain, Chuck" <Chuck_Partain@maxtor.com>
Date: Tue, 28 Feb 2006 09:22:00 -0500
List-post: <mailto:amps@contesting.com>
good portable antenna AND it'll make you hungry for Mcdonalds fries at some 
point :)

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Larry Carman
Sent: Tuesday, February 28, 2006 9:20 AM
To: 'HAROLD B MANDEL'
Cc: amps@contesting.com
Subject: Re: [Amps] Vegetable oil dummy load



The cantenna I was using was a makeshift for testing a 3cpx5000a7 homebrewed
amp I had constructed. I used 3 gallons of veggie oil in a plastic storage 
container. I drown nine, 18" long carborundum resistors in the oil and 
covered the container with a thick aluminum plate. I could only test to 2500
watts output because of the bird 2500 watt element limitation. But, I could
test for a long, long time. 
   With the dummyload lying on the concrete floor in the garage, I figured
it wouldn't radiate very well. One morning I forgot to switch from the
dummyload to the trapped 40/80 inverted vee and ended up QSOing a friend 200
miles away on 75 mtrs with S9 signal. 
   The veggie oil works pretty good for a while but tends to
gum up at hot points. This might be remedied by putting some type of
pump/circulator inline. Seems like lots of trouble for a dummy load but the
veggie oil is available locally at about 1/4 the cost of mineral oil. I have

no idea what the flash point is for veggie oil. Could be dangerous.

Larry N5BIP

-----Original Message-----
From: HAROLD B MANDEL [mailto:ka1xo@juno.com] 
Sent: Tuesday, February 28, 2006 6:54 AM
To: lncarman@swbell.net
Subject: Re: [Amps] figuring tube output impedance

Hi Larry,

Remember 2 years ago when I was in a hotel in NJ and tried out
one of them tetrode Emtron DX-3's?

I used a Cantenna, too, and it got so hot in a few seconds of tuning
the steam was coming out the escape hole: "TSSSSST!"

Too bad it had a power supply with 18% sag on key down.

Imagine what a great amp it would be if the designers didn't
cut corners on everything?

I'm a-building another amp in my hotel room these days. The outboard
supply is meant to be desktop, but I can't lift it hardly
anymore and the covers and panels aren't even on yet!

I started with an Alpha 76 husk and put in some 3CPX800A7's with
elevated plate voltage and ampacity.  The PSU is rated at
2 amperes CCS. BOOM!

Hal
W4HBM

On Mon, 27 Feb 2006 18:44:42 -0600 "Larry Carman" <lncarman@swbell.net>
writes:
> 
> With 3900 watts you can fry tasty chicken in the dummy load if you 
> use
> vegetable oil. Think the FCC would fall for that one???
> ... I actually had a dummy load filled with vegetable oil. Worked ok 
> but oil
> gummed up around the heated metal contact points after a while. 
> Regards,
> N5BIP
> 
> -----Original Message-----
> From: amps-bounces@contesting.com 
> [mailto:amps-bounces@contesting.com] On
> Behalf Of Partain, Chuck
> Sent: Monday, February 27, 2006 2:41 PM
> To: Bill Turner; amps@contesting.com
> Subject: Re: [Amps] figuring tube output impedance
> 
> yea they're going to love me. 
> 
> and I guess with that line of thinking, I should drive home doing 
> 145 in the
> 40.
> 
> 
> 
> -----Original Message-----
> From: Bill Turner [mailto:dezrat@copper.net]
> Sent: Monday, February 27, 2006 3:37 PM
> To: Partain, Chuck; amps@contesting.com
> Subject: Re: [Amps] figuring tube output impedance
> 
> 
> ORIGINAL MESSAGE:
> 
> At 10:36 AM 2/27/2006, Partain, Chuck wrote:
> 
> >I run 3.9kv and I'm GUESSING 2 amp.
> 
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> I'm GUESSING the FCC will be very interested in your amp.
> 
> Even at a lousy 50% efficiency that is 3900 watts output.
> 
> Bill, W6WRT
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
> 


Harold Mandel
Superintendent of Construction
Baran Telecom Inc.
606 - 205 - 0172
hmandel@barantelecom.com

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>