Amps
[Top] [All Lists]

Re: [Amps] Designing the Cleanest Linear with RF Negative Feedback

To: garyschafer@comcast.net
Subject: Re: [Amps] Designing the Cleanest Linear with RF Negative Feedback
From: "Bill L. Fuqua" <wlfuqu00@uky.edu>
Reply-to: wlfuqu00@uky.edu
Date: Sun, 18 Dec 2005 18:38:34 -0500
List-post: <mailto:amps@contesting.com>
Just looked at the article. Seems to be what I suggested earlier.  Low mu 
triode in grounded grid. The advantage of  a 4CX tube with control grid 
connected to the cathode requires no bias voltage and is should have very 
little screen current, if any.  
If you look at the article you will see all the drive power goes to the output.

73
Bill wa4lav

-----Original Message-----
From: Gary Schafer <garyschafer@comcast.net>
To: Tom Cathey <K1JJ@comcast.net>
Date: Sun, 18 Dec 2005 16:48:11 -0500
Subject: Re: [Amps] Designing the Cleanest  Linear with RF Negative Feedback


Hi Tom,

Here is some more info for you to look at. Qst July 1967 page 34 is an 
article by Orr on super cathode driven amps. He shows the difference in 
IM performance on the 4CX350 in this configuration which if I remember 
right is about 15 db better than grid driven.

Other good stuff in the article about feedback too.

73
Gary  K4FMX


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>