B&W Catalog says it is a filament choke for grounded grid amplifiers,
covering "80 through 10 meters inclusive, requiring no tuning. Used with
standard types of filament transformers......for one or two tubes requiring
a total of not more than 30 amps". I think the A version is the same, but
without the steel case, but that is not in my catalog. Good memory,
Mike!--Mike, WV2ZOW
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Mike McCarthy, W1NR
Sent: Thursday, December 01, 2005 8:18 PM
To: 'Angelo Karabetsos'; amps@contesting.com
Subject: Re: [Amps] B&W FC-30 RFC
I am recalling this from memory, but I am pretty sure it was 3-30 MHz at 30
amps.
Mike, W1NR
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Angelo Karabetsos
Sent: Thursday, December 01, 2005 5:15 PM
To: amps@contesting.com
Subject: [Amps] B&W FC-30 RFC
Hello All,
Does anybody have any specifications on an old B&W FC-30 filament choke? I
have seen a FC-30A floating around but but not this model in particular.
73 VE3YN
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|