It sounds like your T/R relay contacts are dirty. That's the
first place I'd check. If it's an open frame relay it's probably the
culprit.
For testing purposes always use a dummy load.
Keep the other hand in your pocket.
Hal
W4HBM
On Mon, 21 Nov 2005 22:10:56 -0500 ashley newell <anewell@alltel.net>
writes:
> hi all,
> i have an sb-200, that has all the harbach mods etc., that has been
> in
> storage for a few years.
> i hooked it up to my station, and with a small amount of drive, the
>
> output swr is off the scale!!
> with the amp turned off, and signal running through it, i have abt a
> 1.4
> to 1, which is the antenna swr.
> any help?
>
> de kn4nn
> --
>
>
=========================================================================
=======
>
> J. ASHLEY NEWELL
>
> anewell@alltel.net
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Harold Mandel
Const. Supt.
Baran/Greenville
606 - 205 - 0172
hmandel@barantelecom.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|