Amps
[Top] [All Lists]

Re: [Amps] Aluminum alloys for panels?

To: "Jim Kearman" <jkearman@att.net>, "Amps" <amps@contesting.com>
Subject: Re: [Amps] Aluminum alloys for panels?
From: "David C. Hallam" <dhallam@rapidsys.com>
Reply-to: dhallam@rapidsys.com
Date: Tue, 15 Nov 2005 17:07:21 -0500
List-post: <mailto:amps@contesting.com>
Jim,

5052 will work OK.  Go to you local metal salvage yard, i.e., scrap yard and
see what you can find.  I have gotten some pieces of aluminum sheet at
attractive prices.  Don't worry about what alloy it is.

David
KC2JD

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Jim Kearman
Sent: Monday, November 14, 2005 11:47 PM
To: Amps
Subject: [Amps] Aluminum alloys for panels?


I need to make two panels and a baseplate for an amp. I could cut down 19"
panels but would like to find a cheaper way. Does anyone know what alloy of
aluminum is used for rack panels? I was thinking it was 6061 but I can't
find it in .125-inch thickness. The hardest I can find in that thickness is
5052. This link compares them for hardness and machinibility:

http://www.smallparts.com/products/descriptions/sma.cfm

The baseplate is going to be about 17"x17" and has to hold a 33-lb
transformer and the rest of the amp, so it needs to be fairly stiff. I'd
like the panels to be stiff as well, especially the back, where I'll be
hanging a heavy blower. Is 5052 okay? Thanks.

73,

Jim, KR1S
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>