Bill,
One thing about conduction cooled tubes to me is that there is a hot spot at
180 degrees from where it mounts to the heatsink. A convection cooled tube with
heat fins has cool air passing over these fins 360 degrees around the
circumferance. I'm not sure if any tests have been done, but this may lead to
the conduction tube failing before the convection one, I don't know.
Best,
Will
*********** REPLY SEPARATOR ***********
On 11/3/05 at 1:26 PM Bill Fuqua wrote:
>If a tube is convection, conduction, radiation, liquid or vapor phase
>cooled has to do with how heat ,produced by the kinetic energy from
>colliding electrons, is removed from the anode. From there it may pass
>from one place to another until ultimately dissipated into the environment
>by all sort of heat transfer mechanisms. There are some very minor points
>about this that can be argued, such as, in the case of the convection
>cooled tubes or even the radiation cooled tubes where there is thermal
>conduction from the side of the anode where the electrons collide to the
>surface where it is dissipated. But that is a very minor point except to
>the nitpicking purest.
>
>73
>Bill wa4lav
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|