To all with PSU Designer software experience:
I have modeled my PS in PSU Designer but I am seeing strange effects.
I have a 2.5 kV transformer with a secondary impedance of 7.5 Ohm. I
have a set of SKN3F20-08 diodes lined up in strings of 8 diodes in
series in each leg. The total capacity of my cap bank is 300uF with
an ESR of 0.47 Ohm for each cap.
I have planned to use a Globar model 888SP 50 Ohm 200 Watt resistor
as a glitch R.
Now I want to know what my output voltage is doing when I switch from
Receive to Transmit... assuming I am doing RTTY....
How do I correctly model this with the software to simulate the output ?
Thanks for any hints!
73 Frank DG1SBG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|