another thought...is there a tuned input/cathode circuit, or is it direct-feed?
At 07:27 2005-10-11, Bruce Lanning wrote:
>Several years ago, I built a GG amplifier using a pair of 4-400A. The grid
>and screen are grounded at the tube socket.
>
>I feel that the power out is quite low. Below are some of the operating
>parameters:
> Measured power out: 855 watts
> Power input: 1216 Watts
> Ep:3200 Volts
> Ip: 380 Ma.( at max output)
> Ig: 250 Ma.
> Eg: Bias 00
> Static Ip: 120 Ma.
>
>I am using the B&W Pi-network, model 850A output tuning inductor
>.
>I have checked the tube filament pins for a poor solder joint.
>They both looked OK, but I resoldered them to no avail.
>
>Maybe someone out there could throw some light on my problem, or if I even
>have a problem...
>
>
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|