Amps
[Top] [All Lists]

Re: [Amps] Question

To: amps@contesting.com
Subject: Re: [Amps] Question
From: "Will Matney" <craxd1@verizon.net>
Reply-to: craxd1@verizon.net
Date: Sat, 01 Oct 2005 13:12:30 -0400
List-post: <mailto:amps@contesting.com>
William,

That's the way I always heard it too!

*********** REPLY SEPARATOR  ***********

On 10/1/05 at 8:46 AM Dr. William J. Schmidt, II wrote:

>You can't.  A gettering "fixes" the gas molecules permanently to the 
>gettering material, so the partial pressure in the tube drops.  Arcing
>does 
>nothing... the gas molecules are still present and the pressure stays the 
>same.
>
>Sincerely,
>
>Dr. William J. Schmidt, II  K9HZ
>Trustee of the North American QRO - Central Division Club - K9ZC
>
>Email: bill@wjschmidt.com
>WebPage: www.wjschmidt.com
>
>"If computers get too powerful, we can organize them into a committee;
>that 
>will do them in."  -- Bradley's Bromide
>
>
>----- Original Message ----- 
>From: "Will Matney" <craxd1@verizon.net>
>To: <amps@contesting.com>
>Sent: Saturday, October 01, 2005 7:59 AM
>Subject: [Amps] Question
>
>
>> How can you "getter" a tube by an arc over a bad vacuum? How can just an 
>> arc cause the amount of gas in a gassy tube to drop? We're not talking 
>> about using true getters here, just an arc happening in a tube either
>new 
>> or old that is gassy. Every tube I've ever seen do this arcing would
>keep 
>> doing it and a gassy tube is a bad tube or the way I was taught.
>>
>> Best,
>>
>> Will
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>