All,
I just finished sacrificing 12" of Teflon bar stock to the 2xGS35b
project this evening. The result is a 320uH inductor in 2 sections. I
will sweep the unit tomorrow at work and report back with the resonance
story. The basics are as follows:
Wire: 24AWG
OD of coils: approx. 39mm
Form 1: Coil 1: 25mm
Form 1: Coil 2: 27mm
Form 1: Coil 3: 49mm
Form 2: Coil 1: 26.5mm
Form 2: Coil 2: 24mm
Form 2: Coil 3: 18mm
Form 2: Coil 4: 27mm
The coils are parallel (against conventional wisdom) Center to Center
separation: 85mm. It certainly looks cool. I plan on adding a HV
capacitor and relay at the connection point if necessary to switch out
~1/2 of the inductance if necessary.
Tomm, KD7QAE
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|