N7KA wrote:
>Someone asked about bend allowance for sheet metal. If needed contact
>me off line as I have info needed to do calcs from work. We de do a
>LOT of sheet metal fab work and forming is ongoing continuous process
>for us (mostly aluminum up to .25 inch).
Staying on-line... what's the trick to prevent alumin(i)um from
splitting on the outside edge of a bend where it is stretched?
--
73 from Ian G/GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|