On Jul 12, 2005, at 9:00 AM, Vic Rosenthal wrote:
> Ian White GM3SEK wrote:
>
>> In glass/metal tubes that operate
>> with a very hot anode, the getter is on the anode itself. In
>> ceramic/metal tubes that operate with a relatively cool anode, the
>> getter is usually on the cathode because that is the hottest place.
>
> Which seems to imply that when putting a tube in service that has been
> stored for some time, the way to activate the getter depends on the
> tube
> type. Filament voltage alone should work for a ceramic tube while a
> 3-500Z or similar should have enough plate current flowing to heat the
> anode. Is this correct?
Good logic, Vic. This is why actually operating a new 3-500Z is the
only way possible to activate the getter. Applying only
filament-voltage for 24-hours to "condition" a 3-500Z is yet another
laughable old wives' tale in Ham radio.
cheerz
>
> --
> 73,
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Rich Measures, 805.386.3734, AG6K, www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|