JAMES SMITH wrote:
> I have an amplifier that runs 2 x 3-500z's and the filament voltage
> is 2.5 volts when it should be 5.0v.The amp is currently wired to
> 110VAC and I would like to wire it to 220VAC. Which will cure the
> problem, or should. Anyone have any suggestions on how to wire it up?
> any suggestions would be great.
It is obviously wired incorrectly now, or something is seriously wrong.
Without knowing the type of amplifier (make/model, homebrew) it's
impossible to give you advice about what to do. Even then, your problem
could be tricky.
I don't want to come off as a wiseass, but my impression from the way
you phrased your question is that you should get someone experienced to
help you. Amplifiers can be quite dangerous, as you probably know.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|